Coolant temperature this AIO settles at over fan rpm, its dissipation in W/K, and the noise of its 2 stock fans. Calculated from the radiator size and thickness and the stock fan's datasheet with the RadiatorTemp model. Not measured; the bands show the spread.
| fan rpm | CFM through core | W/K | Coolant above intake, 250 W | Coolant at 30 °C intake | dB(A), 2 fans |
|---|---|---|---|---|---|
| 480 min | 18 | 6.5 | +38.4 | 68.4 °C | – |
| 720 | 27 | 8.3 | +30.1 | 60.1 °C | – |
| 960 | 36 | 9.9 | +25.3 | 55.3 °C | – |
| 1200 | 45 | 11.3 | +22.2 | 52.2 °C | – |
| 1440 | 55 | 12.6 | +19.9 | 49.9 °C | – |
| 1680 | 64 | 13.8 | +18.1 | 48.1 °C | – |
| 1920 | 73 | 15.0 | +16.7 | 46.7 °C | – |
| 2160 | 82 | 16.1 | +15.6 | 45.6 °C | – |
| 2400 | 91 | 17.1 | +14.6 | 44.6 °C | – |
Model values; the ±15 % band is drawn in the charts above. Change heat load, intake and target in the database view.
No noise rating for the stock fan in the data.
A radiator moves heat in proportion to the difference between coolant and incoming air: Q = q · (Tcoolant − Tair).
q depends on the air actually passing through the core. Airflow per fan is CFMmax · derate · rpm/rpmmax
with the radiator derate (0.62, or 0.72 for pressure-optimized blades) times the core-thickness factor. Per 120 mm segment at 27 mm:
q = 8.5 W/K · (airflow / 45 CFM)0.6; heat transfer over fins scales with roughly the 0.6 power of velocity.
| Core | Airflow factor | Fin area factor |
|---|---|---|
| 27 mm | 1.00 | 1.00 |
| 30 mm | 0.97 | 1.09 |
| 38 mm | 0.90 | 1.15 |
| 45 mm | 0.84 | 1.22 |
Thick cores gain fin area but lose airflow; at low rpm the net is close to zero. With fans off, natural convection is taken as 1 W/K per segment.
The band is ±15 % on q: fin density, coolant flow and preheated case air. Pump speed matters little above roughly 1 l/min.
Noise is the stock fan's curve plus 10 · log₁₀(fan count).
Air entering the radiator is case air, usually 5 to 10 K above room. Die temperatures sit above the coolant by the block and TIM delta, typically 25 to 45 K under load. Nothing here is measured; the same model runs in RadiatorTemp.